This option is not available for all connections. Enable the option SIMATIC NET if SIMATIC NET was installed during the network transition and you wish to use this.Enable the option Exclude (SBSs) system program blocks if you do not want to save these program blocks (SBSs) in the SPS hardware configuration.You need to decide which program blocks you do not want to be saved in the backup.Program blocks with no changes are taken over from the previous back up. The latter one will be examined based on the time stamp. If this option is activated, only new and edited program blocks are transferred. To reduce the strain on your resources and network, activate the option Upload only when timestamp is different (reduces network load).For more information, see the section: configure access path In the access path, select the access path that you want to use to communicate with the deviceĭepending on your choice, other input fields for further configuration will be appear.If a project is present, this project will be automatically selected. You can only select projects that are located in checked-in components. Select the project that you want to execute a job for.Configure the section SIMATIC S7 settings.For more information on configuring the general sections, please refer to jobs in the tutorial AdminClient. The notification and create a version automatically after job run sections are only displayed if the necessary settings have been implemented. Make sure the desired settings are in place for the following sections: general, notification, upload and compare, create a version automatically after job run.In the menu tab, click on create or drag & drop the components into the jobs section.Ĭheck in the section job configuration, if the upload type SIMATIC S7 is being displayed.In the project tree, select the Schneider S7 component.Start the AdminClient and open the jobs module.To create jobs for SIMATIC STEP7 controllers: Create interim backup copies for disaster recovery.(differences can be shown and analysed in detail). If the program on the device corresponds to the most recently checked-in version on the server.In versiondog, you have the option to create jobs that regularly check: Versiondog 9.0.0: SIMATIC S7: creating jobs

Simatic step 7 v5.5